INSTALL SHIFT PADDLE SWITCH

ADJUST SPIRAL CABLE SUB-ASSEMBLY

INSTALL STEERING WHEEL ASSEMBLY

INSTALL STEERING PAD

INSTALL LOWER NO. 3 STEERING WHEEL COVER

INSTALL LOWER NO. 2 STEERING WHEEL COVER

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

PERFORM INITIALIZATION

INSPECT STEERING PAD

INSPECT SRS WARNING LIGHT

Install the 2 shift paddle switches and 2 brackets with the 4 screws.

• Torque:
• 1.7 N*m{ 17 kgf*cm, 15 in.*lbf}

• NOTICE:

• Make sure that the brackets are securely installed.

Connect the 2 switch wire connectors to the shift paddle switches.

Install the connector to the steering wheel assembly.

Install the clamp to the steering wheel assembly.

Check that the engine switch is off.

Check that the battery negative (-) terminal is disconnected.

• CAUTION:

• After removing the terminal, wait for at least 90 seconds before starting the operation.

Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.

• NOTICE:

• Do not turn the spiral cable with steering sensor by the airbag wire harness.

Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.

• NOTICE:

• Do not turn the spiral cable with spiral sensor by the airbag wire harness.

• HINT:

• The spiral cable with steering sensor will rotate approximately 2.5 turns to both the left and right from the center.

Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

Install the steering wheel assembly set nut.

• Torque:
• 50 N*m{ 510 kgf*cm, 37 ft.*lbf}

Support the steering pad with one hand as shown in the illustration.

Connect the 2 connectors to the steering pad.

• NOTICE:

• When handling the airbag connector, take care not to damage the airbag wire harness.

Connect the horn connector.

Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.

• Torque:
• 8.8 N*m{ 90 kgf*cm, 78 in.*lbf}

Install the steering wheel No.3 cover lower.

Install the steering wheel No.2 cover lower.

With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:

Make sure that the horn sounds.

• HINT:

• If the horn does not sound, inspect the horn system .

Inspect the SRS warning light .