Front Wiper Motor And Link Installation

Install the wiper motor with the 3 bolts.

Torque:

5.4 N*m{55 kgf*cm, 48 in.*lbf}

Align the matchmarks on the crank arm and motor.

Apply MP grease to the sliding parts of the wiper motor and the rod of the wiper link.

Connect the rod of the wiper link to the wiper motor.

Connect the connector and attach the clamp.

Move the wiper motor and link in the direction shown by the arrow in the illustration to attach the wiper cushion to the body, and install the wiper motor and link.

Install the 2 bolts.

Torque:

5.5 N*m{56 kgf*cm, 49 in.*lbf}

Attach the 12 claws and install the louver.

Install the 2 clips.

Attach the claw to install the front fender to cowl side seal.

Attach the claw to install the front fender to cowl side seal.

Stop the wiper motor at the automatic stop position.

Clean the wiper arm serration with a round file or equivalent.

Clean the wiper pivot serration with a wire brush.

Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

Torque:

26 N*m{265 kgf*cm, 19 ft.*lbf}

HINT:

Hold down the arm hinge with your hand while tightening the nut.

Clean the wiper arm serration with a round file or equivalent.

Clean the wiper pivot serration with a wire brush.

Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

Torque:

26 N*m{265 kgf*cm, 19 ft.*lbf}

HINT:

Hold down the arm hinge with your hand while tightening the nut.

Operate the front wipers while spraying water or washer fluid on the windshield. Ensure that there is no interference between the blades and pillar.

Install the 2 caps.