Theft Deterrent System Theft Warning Siren Circuit
Securities. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK THEFT WARNING SIREN ASSEMBLY
CHECK WIRE HARNESS (THEFT WARNING ECU - THEFT WARNING SIREN)
CHECK WIRE HARNESS (THEFT WARNING SIREN - BODY GROUND)
THEFT DETERRENT SYSTEM - Theft Warning Siren Circuit |
DESCRIPTION
The theft warning siren has an internal battery. If the vehicle's battery or any of the communication lines is open, the theft warning siren detects it by itself and sounds. Although the theft warning siren usually sounds by receiving a signal from the theft warning ECU, the theft warning siren can sound by its internal battery in case the vehicle's battery is open.The theft warning ECU sends an arming signal to the theft warning siren while transferring to the armed state, and it also sends a disarming signal to the siren while switching to the disarmed state. Also, the theft warning ECU can cause the theft warning siren to sound by sending an alarm signal during the alarm sounding state.
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK THEFT WARNING SIREN ASSEMBLY |
Measure the voltage of the siren.
- Standard voltage:
Tester Connection
| Condition
| Specified Condition
|
L17-1 (+B) - Body ground
| Always
| 10 to 14 V
|
L17-2 (GND) - Body ground
| Always
| Below 1 V
|
L17-3 (CONT) - Body ground
| When switched from armed state or arming preparation state to disarmed state (1)
| Wave pattern (1) shown in chart
|
When switched from arming preparation state to disarmed state (2)
| Wave pattern (2) shown in chart
|
Normal Condition
| Approx. 1. 4 V
|
| REPLACE THEFT WARNING SIREN |
|
|
2.CHECK WIRE HARNESS (THEFT WARNING ECU - THEFT WARNING SIREN) |
Disconnect the E83 ECU connector.
Disconnect the L17 siren connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
| Specified Condition
|
E83-28 (CTLS) - L17-3 (CONT)
| Below 1 Ω
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
3.CHECK WIRE HARNESS (THEFT WARNING SIREN - BODY GROUND) |
Disconnect the L17 siren connector.
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
| Specified Condition
|
L17-2 (GND) - Body ground
| Below 1 Ω
|
| REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
|
OK |
|
|
|
REPLACE THEFT WARNING ECU |
|