Front Seat Inner Belt Assembly Removal

Lift up the seat track adjusting handle and move the seat to the foremost position.

Using a screwdriver, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.

Remove the outer cover in the direction indicated by the arrow in the illustration.

Using a screwdriver, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.

Remove the inner cover in the direction indicated by the arrow in the illustration.

Use the same procedures described for the LH side.

Use the same procedures described for the LH side.

Operate the power seat switch knob and move the seat to the foremost position.

Using a screwdriver, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.

Remove the front seat track bracket outer cover in the direction indicated by the arrow in the illustration.

Using a screwdriver, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.

Remove the front seat track bracket inner cover in the direction indicated by the arrow in the illustration.

Remove the 2 bolts on the rear side of the seat.

Operate the power seat switch knob and move the seat to the rearmost position.

Remove the 2 bolts on the front side of the seat.

Operate the power seat switch knob and move the seat to the center position. Then, operate the power seat switch knob and move the seatback to the upright position.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

Disconnect the connectors under the seat.

Remove the seat.

NOTICE:

Be careful not to damage the vehicle body.

Remove the 2 bolts on the rear side of the seat.

Lift up the seat track adjusting handle and move the seat to the rearmost position.

Remove the 2 bolts on the front side of the seat.

Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

Disconnect the connector under the seat.

Remove the seat.

NOTICE:

Be careful not to damage the vehicle body.

Disconnect the rubber band of the front seatback board from the front seat frame assembly (w/ adjuster).

Remove the 5 screws.

Using a screwdriver, detach the 3 claws and remove the cushion shield (with front No. 1 seat cushion inner shield).

HINT:

Tape the screwdriver tip before use.

Disconnect the connector from the front power seat lumbar switch.

Remove the front No. 1 seat cushion inner shield from the cushion shield.

1. Remove the screw.
   

2. Using a screwdriver, detach the claw and remove the inner shield.
   

   HINT:

   Tape the screwdriver tip before use.

Disconnect the rubber band of the front seatback board or front seatback cover from the front seat frame assembly (w/ adjuster).

Remove the 2 screws.

Using a screwdriver, detach the 3 claws and remove the cushion shield.

HINT:

Tape the screwdriver tip before use.

for Driver Seat:
Disconnect the 2 connectors and detach the 2 clamps.

for Passenger Seat:
Disconnect the connector and detach the 2 clamps.

Remove the nut and seat belt.

for Driver Seat:
Disconnect the 2 connectors and detach the 3 clamps.

for Passenger Seat:
Disconnect the 2 connectors and detach the 3 clamps.

Remove the nut and seat belt.