Rear Upper Control Arm Removal
Suspension. Toyota Rav4. Aca30, 33, 38 Gsa33 Zsa30, 35
REMOVE REAR WHEEL
REMOVE SKID CONTROL SENSOR WIRE (for 2WD)
REMOVE REAR SPEED SENSOR LH (for 4WD)
REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH
Rear Upper Control Arm -- Removal |
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
| 2. REMOVE SKID CONTROL SENSOR WIRE (for 2WD) |
Disconnect the skid control sensor wire connector.
Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.
Remove the bolt (labeled A) and sensor clamp (labeled B) from the side member.
Remove the 2 nuts (labeled C) and 2 sensor clamps (labeled D) from the upper arm.
Remove the bolt (labeled E) and sensor clamp (labeled F) from the carrier.
Disconnect the skid control sensor wire connector (labeled G) from the skid control sensor.
| 3. REMOVE REAR SPEED SENSOR LH (for 4WD) |
Disconnect the speed sensor connector.
Disconnect the grommet of the speed sensor wire from the hole of the wheel house.
Remove the bolt (labeled A) and sensor clamp (labeled B) from the side member.
Remove the 2 nuts (labeled C) and sensor clamps (labeled D) from the upper arm.
Remove the nut (labeled E) and sensor clamp (labeled F) from the trailing arm.
Remove the bolt (labeled G) and sensor body (labeled H) from the carrier.
- NOTICE:
- Keep the sensor tip and sensor installation hole free from foreign matter.
| 4. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH |
Support the No. 2 suspension arm.
Remove the 2 bolts and 2 nuts, and disconnect the upper control arm.
- NOTICE:
- When removing the bolts, hold the nuts in place.
