Water Pump -- Removal |
1. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 6 screws, 10 clips and under cover.
![]() |
2. REMOVE REAR ENGINE UNDER COVER RH |
Remove the 3 clips and under cover.
![]() |
3. REMOVE RADIATOR SUPPORT OPENING COVER |
Remove the 9 clips and radiator support opening cover.
4. REMOVE NO. 2 CYLINDER HEAD COVER |
Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.
- NOTICE:
- Attempting to detach both front and rear clips at the same time may cause the cover to break.
![]() |
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- w/ Navigation System (for HDD):
- After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
6. DRAIN ENGINE COOLANT |
Install a vinyl hose to the drain cock plug on the radiator side.
![]() |
Loosen the radiator drain cock plug.
- HINT:
- Collect the coolant in a container and dispose of it according to the regulations in your area.
Remove the radiator reservoir cap.
- CAUTION:
- Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
7. REMOVE V-RIBBED BELT |
Loosen bolts A and B.
![]() |
Loosen bolt C and remove the V-ribbed belt.
- NOTICE:
- Do not loosen bolt D.
8. REMOVE GENERATOR ASSEMBLY |
Remove the terminal cap.
![]() |
Remove the nut and disconnect the wire harness from terminal B.
Disconnect the connector and wire harness clamp.
Loosen the 3 bolts.
![]() |
Remove the 2 bolts and adjusting bar.
![]() |
Remove the bolt and generator.
![]() |
Remove the bolt and wire harness clamp bracket.
![]() |
9. REMOVE WATER PUMP ASSEMBLY |
Remove the 5 bolts and water pump from the timing chain cover.
![]() |
Remove the gasket from the timing chain cover.
![]() |