Fuel Pressure Pulsation Damper Installation

Apply a light coat of gasoline or spindle oil to the O-ring of the fuel pressure pulsation damper.

Install the fuel pressure pulsation damper with the 2 bolts.

Torque:

9.0 N*m{90 kgf*cm, 80 in.*lbf}

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing.

Connect the fuel main tube.

Push the fuel tube connector until it makes a "click" sound.

Install the fuel pipe clamp.

Install the fuel tube to the fuel hose clamp.

Install the air cleaner filter element onto the air cleaner case.

Insert the hinge part of the air cleaner cap into the air cleaner case, then hang the 2 hook clamps.

Align the matchmarks of the No. 1 air cleaner hose and throttle body, and then connect the air cleaner hose No. 1 to the throttle body and unfasten the No. 1 air cleaner hose clamp.

NOTICE:

Make sure that the hose clamp is at the correct angle.

Connect the purge line hose to the clamp.

Connect the No. 2 ventilation hose to the air cleaner hose.

Connect the 4 wire harness clamps.

Connect the mass air flow meter connector.

Install the cover with the 2 nuts.

Torque:

7.0 N*m{71 kgf*cm, 62 in.*lbf}

Make sure that there are no fuel leaks after performing maintenance on the fuel system.

1. Connect the intelligent tester to the DLC3.
   

2. Turn the ignition switch on (IG), and push the intelligent tester main switch ON.
   

   NOTICE:

   Do not start the engine.

3. Select the Active Test mode on the intelligent tester.
   

   HINT:

   Refer to the intelligent tester operator's manual for further details.

4. Check that there are no leaks from the fuel system.
   

5. Turn the ignition switch off.
   

6. Disconnect the intelligent tester from the DLC3.