Dtc B2313 Glass Position Initialization Incomplete


DESCRIPTION

INSPECTION PROCEDURE

PERFORM INITIALIZATION (APPLICABLE LOCATION)

CHECK DTC

DTC B2313 Glass Position Initialization Incomplete


DESCRIPTION

The power window regulator motor is driven by operating the power window switch. The power window regulator motor assembly has a motor, regulator and ECU.
When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.
HINT:
This DTC may be stored for all the windows.
NOTICE:
  1. When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
  2. After any door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:
    1. Close the power window by fully pulling up the power window switch and holding it in the auto up position.
    2. Open the power window by fully pushing down the power window switch.

D-Door Motor
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
  1. Front power window regulator motor LH*1
  2. Front power window regulator motor RH*2
  1. *1: for LHD
  2. *2: for RHD

P-Door Motor
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
  1. Front power window regulator motor RH*1
  2. Front power window regulator motor LH*2
  1. *1: for LHD
  2. *2: for RHD

RL-Door Motor (for 5 Door)
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
Rear power window regulator motor LH

RR-Door Motor (for 5 Door)
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
Rear power window regulator motor RH

INSPECTION PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)

  1. Initialize the power window regulator motor (LandCruiser RM0000011V20BLX.html).


NEXT


2.CHECK DTC

  1. Check for DTCs (LandCruiser RM000000YCC0CHX.html).

    OK:
    DTC B2313 is not output
    Result
    Result
    		Proceed to
    No DTCs output
    		A
    DTC output (Front power window LH)
    		B
    DTC output (Front power window RH)
    		C
    DTC output (Rear power window LH)*
    		D
    DTC output (Rear power window RH)*
    		E
    1. *: for 5 Door


B
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (LandCruiser RM0000011QF0H4X.html)

C
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (LandCruiser RM0000011QF0H4X.html)

D
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (LandCruiser RM0000011RX0CAX.html)

E
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (LandCruiser RM0000011RX0CAX.html)
A

END (POWER WINDOW CONTROL SYSTEM WAS NOT INITIALIZED)