Rear No. 1 Seat Assembly (For 60/40 Split Slide Walk-In Seat Type Rh Side) -- Installation |
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1. INSTALL REAR SEAT ASSEMBLY RH |
 |
Place the rear seat assembly RH in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
- HINT:
- Be sure to install the seat with the seatback folded down.
Connect the center inner belt to the rear seat assembly RH.
Temporarily install the rear seat assembly RH with the 5 bolts and nut.
Tighten the bolts and nut in the order indicated in the illustration.
- Torque:
- 37 N*m{377 kgf*cm, 27 ft.*lbf}
w/ Seat Heater System:
Connect the seat heater connector.
| 2. INSTALL SEAT TRACK COVER RH |
Attach the 5 clips and claw to install the seat track cover RH.
| 3. INSTALL SEAT TRACK INNER BRACKET COVER RH |
Attach the 8 clips to install the seat track inner bracket cover RH.
| 4. INSTALL REAR SEAT TRACK OUTER BRACKET COVER |
 |
Move the rear seat track outer bracket cover in the direction of the arrow to attach the 2 guides.
Attach the 2 claws to install the rear seat track outer bracket cover.
| 5. INSTALL REAR SEAT TRACK INNER BRACKET COVER |
 |
Attach the 2 claws and guide to install the rear seat track inner bracket cover.
| 6. INSTALL REAR SEAT HEADREST ASSEMBLY |
Install the rear seat headrest assembly.