Lighting System Operation Check
INSPECT ILLUMINATED ENTRY SYSTEM OPERATION
INSPECT CENTER CONSOLE SPOT LIGHT CONTROL OPERATION
Lighting System -- Operation Check |
INSPECT ILLUMINATED ENTRY SYSTEM OPERATION |
- *1: w/ Entry and Start System
- *2: w/o Entry and Start System
- *3: w/ Side Step Light
- *4: w/ Interior Foot Light
- *5: w/ Door Illumination
- *6: When the lights are on, if the key leaves all detection areas around the doors, after approximately 3 seconds, the lights fade out.
- NOTICE:
- Perform this inspection with the customizable parameters set to the initial settings.
- HINT:
- The illuminated entry system illuminates the lights below.
- Engine switch illumination*1
- Ignition switch illumination*2
- Map light
- No. 1 room light
- No. 2 room light
- Side step light*3
- Interior foot lights*4
- Inside handle illumination*5
- Ornament illumination*5
- Door pocket illumination*5
The operation and conditions of this system are described below.
Operation
| Condition
|
Lights fade in and illuminate constantly
| Any door is opened when all the doors are closed.
|
Lights illuminate for 15 seconds, and then fade out
| When any of the following conditions is met:
- The key is brought within any vehicle exterior detection area when the ignition switch is off and all the doors are closed.*6
- Any door is unlocked when the ignition switch is off and all the doors are closed and locked.
- The ignition switch is turned from ACC to off when all doors are closed.
- All the doors are closed when one or more doors are open and the ignition switch is off.
|
Lights fade out immediately
| When either of the following conditions is met:
- The ignition switch is turned from off to ACC when all the doors are closed.
- All the doors are locked when the ignition switch is off, all the doors are closed and any door is unlocked.
|
Battery saving
| The doors remain in the same condition for 20 minutes and the key is outside the vehicle exterior detection area.*1 The doors remain in the same condition for 20 minutes and the key is not inserted into the ignition key cylinder.*2
|
INSPECT CENTER CONSOLE SPOT LIGHT CONTROL OPERATION |
- NOTICE:
- Perform this inspection with the customizable parameters set to the initial settings.
The operation and conditions of this function are described below.
Operation
| Condition
|
Light fades in
| When either of the following conditions is met, the center console spot light fades in.
- Ignition switch ACC
- Ignition switch ON
|
Light fades out
| Ignition switch off
|