Wireless Door Lock Control System (W/O Entry And Start System) -- How To Proceed With Troubleshooting |
- HINT:
- The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
- Use these procedures to troubleshoot the wireless door lock control system.
- *: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP |
|
2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
|
3.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (LandCruiser RM000002BZF06RX.html).
Clear the DTCs (LandCruiser RM000002BZF06RX.html).
Recheck for DTCs.
Result Result Proceed to DTC is not output A DTC is output B
|
| ||||
|
4.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (LandCruiser RM000001WYA02PX.html).
Result Result Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B
|
| ||||
|
5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (LandCruiser RM000001WYH025X.html).
Terminals of ECU (LandCruiser RM000001WYU022X.html).
Data List / Active Test (LandCruiser RM000002MV903KX.html).
|
6.REPAIR OR REPLACE |
|
7.CONFIRMATION TEST |
| |||||
|
---|