Steering Gear Inspection

Install the nut.

Flip the ball joint stud back and forth 5 times as shown in the illustration.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and check the torque reading on the 5th turn.

Standard Torque:

1.0 to 3.9 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)

Place matchmarks as shown in the illustration.

Temporarily install the 2 steering rack ends to the steering rack.

NOTICE:

Do not fully turn the steering rack without the steering rack ends installed as it may damage the oil seal in the rack housing.

Using SST, fully turn the steering rack right and left 10 times to settle it.

SST

09616-00011

Using SST, turn the control valve and measure the preload.

SST

09616-00011

Standard preload (turning):

Body Type	Engine Type	Specified Condition
for 5 Door	for 1GR, 2TR, 1KD, 1GD	1.6 to 2.3 N*m (16 to 23 kgf*cm, 14 to 20 in.*lbf)
	for 5L	1.5 to 2.2 N*m (15 to 22 kgf*cm, 13 to 19 in.*lbf)
for 3 Door	for 1KD, 2TR, 1GD

HINT:

1. Measure the standard preload at the steering rack neutral point.
   
2. The steering control valve is fully turned when turned 3.0 times. Half of the distance from the fully turned position is the neutral point.
   

After inspecting the preload, align the matchmarks.