Propeller Shaft Assembly -- Disassembly |
| 1. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SLEEVE YOKE SUB-ASSEMBLY |
Place matchmarks on the propeller shaft and sleeve yoke.
Text in Illustration *a Matchmark
 |
Remove the sleeve yoke from the propeller shaft.
| 2. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING |
- HINT:
- Use the same procedure for all rear propeller shaft universal joint spider bearing.
Place matchmarks on the flange yoke and sleeve yoke.
Text in Illustration *a Matchmark
 |
Using a brass bar and hammer, slightly tap in the spider bearing outer races.
 |
Using 2 screwdrivers, remove the 4 snap rings from the grooves.
Using SST, remove the spider bearing from the sleeve yoke.
- SST
- 09332-25010
- HINT:
- Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.
 |
Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.
Text in Illustration *a Hammering Point - HINT:
- Remove the spider bearing on the opposite side using the same procedure.
- NOTICE:
- Do not tap the shaft.
 |
Install the 2 removed spider bearing outer races to the universal joint spider.
 |
Using SST, remove the bearing from the yoke.
- SST
- 09332-25010
- HINT:
- Sufficiently raise the part labeled by A so that it does not come into contact with the bearing.
Clamp the outer bearing race in a vise between aluminum plates and tap off the yoke with a hammer.
Text in Illustration *a Hammering Point
 |
Remove the universal joint spider.