Oil Pressure Sensor Installation


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

  2. ADD ENGINE OIL

  3. INSPECT FOR OIL LEAK

Oil Pressure Sensor -- Installation



1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

  1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    NOTICE:
    Do not apply adhesive to the oil inlet port of the oil pressure sender gauge.

  1. Using a 27 mm deep socket wrench, install the oil pressure sender gauge.

    Torque:
    15 N*m{153 kgf*cm, 11 ft.*lbf}
    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. Connect the engine oil pressure sender gauge connector.



2. ADD ENGINE OIL


3. INSPECT FOR OIL LEAK

  1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.