Power Steering Oil Pressure Switch Installation

Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.

Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

Torque:

21 N*m{210 kgf*cm, 15 ft.*lbf}

NOTICE:

1. When reusing the power steering oil pressure switch, inspect the O-ring.
   
2. Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (connecting surface with pressure feed tube).
   
3. Be careful not to damage the O-ring when installing the power steering oil pressure switch.
   

Connect the power steering oil pressure switch connector.

Check the fluid level.

Jack up the front of the vehicle and support it with stands.

Turn the steering wheel.

1. With the engine stopped, turn the wheel slowly from lock to lock several times.
   

Lower the vehicle.

Start the engine.

1. Run the engine at idle for a few minutes.
   

Turn the steering wheel.

1. With the engine idling, turn the wheel to the left or right full lock position and keep it there for 2 to 3 seconds, and then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.*1
   

2. Repeat *1 several times.
   

Stop the engine.

Check for foaming or emulsification.

Check the fluid level.