Vacuum Switching Valve (For Engine Mounting) Installation

Install the 2 vacuum hoses to the vacuum switching valve sub-assembly.

Install the vacuum switching valve sub-assembly with the bolt and nut.

Torque:

10 N*m{102 kgf*cm, 7 ft.*lbf}

Connect the 3 vacuum hoses to the vacuum switching valve sub-assembly.

Connect the connector and 2 clamps to the vacuum switching valve sub-assembly.

w/ Urea SCR System:

1. Temporarily install the starter assembly.
   

   NOTICE:

   Be careful not to drop the starter assembly.

   HINT:

   Tie the starter assembly with a string.

w/o Urea SCR System:

1. for Manual Transmission:
   Install the starter assembly with the bolt and nut.
   

   Torque:

   68 N*m{693 kgf*cm, 50 ft.*lbf}





2. for Manual Transmission:
   Connect the clutch release cylinder assembly with the 4 bolts, 3 nuts and a new clip.
   

   Torque:

   for bolt A:

   12 N*m{120 kgf*cm, 9 ft.*lbf}

   for bolt B, nut:

   19 N*m{194 kgf*cm, 14 ft.*lbf}

   Text in Illustration

   *a	Bolt A
   *b	Bolt B
   *c	Nut

3. for Automatic Transmission:
   Install the starter assembly with the bolt and 2 nuts.
   

   Torque:

   68 N*m{693 kgf*cm, 50 ft.*lbf}

4. Connect the starter wire with the nut.
   

   Torque:

   21 N*m{215 kgf*cm, 16 ft.*lbf}

5. Connect the starter connector.
   

6. Close the terminal cap.
   

Install the front No. 1 fender apron to frame seal LH with the 6 clips.