Rear No. 1 Seat Assembly (For Lh Side) Reassembly

Install the band to the seat cushion frame.

Using hog ring pliers, install the seat cushion cover to the seat cushion pad with 4 new hog rings.

NOTICE:

1. Be careful not to damage the cover.
   
2. When installing the hog rings, avoid wrinkling the cover.
   

Install the seat cushion cover (with pad) to the seat cushion frame.

HINT:

Make sure that the seat stopper band is not inside the cushion cover.

Attach the 2 claws and install the under cover with the 5 screws.

Attach the 8 claws and hooks. Then install the seat cushion cover to the under cover.

Using a T40 "torx" socket, install the 2 seat tracks to the seat cushion with the 2 "torx" bolts.

Torque:

40 N*m{408 kgf*cm, 30 ft.*lbf}

Install the seat track adjusting handle.

Lift up the seat track adjusting handle and move the seat track to the foremost position.

Using a T40 "torx" socket, tighten the 4 "torx" bolts on the rear side of the seat track.

Torque:

40 N*m{408 kgf*cm, 30 ft.*lbf}

Using a T40 "torx" socket, install the bracket with the 2 "torx" bolts.

Torque:

40 N*m{408 kgf*cm, 30 ft.*lbf}

Using a T40 "torx" socket, install the lock with the plate and 2 "torx" bolts.

Torque:

40 N*m{408 kgf*cm, 30 ft.*lbf}

Connect the lock control cable to the lock.

Install the support spring.

Install the lock control cable to the lock with the E-ring and plate.

Using a T40 "torx" socket, install the lock with the 2 "torx" bolts.

Torque:

40 N*m{408 kgf*cm, 30 ft.*lbf}

Connect the lock control cable to the lock as shown in the illustration.

Install the support spring.

Install the release handle to the rear seat lock through the hole in the rear seat cushion under cover.

Install the seat track adjusting handle.

Install the hinge with the 2 nuts.

Torque:

42 N*m{428 kgf*cm, 31 ft.*lbf}

Install the hinge with the 2 nuts.

Torque:

42 N*m{428 kgf*cm, 31 ft.*lbf}

Install the lock cover with the 2 screws.

Attach the rear seat lock control cable to the lock cover's claw.

Install the lock cover with the 7 screws.

Install the reclining remote control lever knob with the screw.

Install the belt with the bolt.

Torque:

42 N*m{428 kgf*cm, 31 ft.*lbf}

Using hog ring pliers, install the seatback cover to the seatback pad with 2 new hog rings.

Install the seatback cover (with pad) to the seatback frame.

Install the 2 headrest supports.

Close the zipper and attach the hooks.

Install the seatback with the 4 bolts.

Torque:

50 N*m{510 kgf*cm, 37 ft.*lbf}

Attach the 3 claws to install the reclining cover.

Install the screw.

Attach the 4 claws to install the reclining cover.

Install the screw.

Install the release handle with the screw.