Power Window Control System (For Rhd) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh


DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY (POWER SOURCE)

INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

CHECK WIRE HARNESS (REGULATOR SWITCH - REGULATOR MOTOR)

INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY

CHECK WIRE HARNESS (MASTER SWITCH - REGULATOR SWITCH)

INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Rear RH Switch)

POWER WINDOW CONTROL SYSTEM (for RHD) - Rear Power Window RH does not Operate with Rear Power Window Switch RH


DESCRIPTION

If the rear RH side manual UP / DOWN function does not operate, a malfunction may be present in the power window regulator motor, power window regulator switch, power window regulator master switch or wire harness.

WIRING DIAGRAM


Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Windshield Windowglass.Power Window Control System (For Rhd).Power Window Control System (For Rhd) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh


INSPECTION PROCEDURE

1.CHECK POWER WINDOW REGULATOR SWITCH ASSEMBLY (POWER SOURCE)
Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Windshield Windowglass.Power Window Control System (For Rhd).Power Window Control System (For Rhd) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Disconnect the P13 regulator switch connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    P13-3 - Body ground
    		Ignition switch ON
    		10 to 14 V


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Windshield Windowglass.Power Window Control System (For Rhd).Power Window Control System (For Rhd) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Remove the switch (Toyota Fortuner RM00000138Z003X.html).

  1. Measure the resistance of the switch when the switch is operated.

    Standard resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    5 - 4, 2 - 3
    		UP
    		Below 1 Ω
    5 - 4, 2 - 1
    		OFF
    		Below 1 Ω
    5 - 3, 2 - 1
    		DOWN
    		Below 1 Ω


NG
REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY
OK


3.CHECK WIRE HARNESS (REGULATOR SWITCH - REGULATOR MOTOR)

Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Windshield Windowglass.Power Window Control System (For Rhd).Power Window Control System (For Rhd) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Disconnect the P13 switch connector.

  1. Disconnect the P10 motor connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    		Specified Condition
    P13-5 - P10-1
    		Below 1 Ω
    P13-2 - P10-2
    		Below 1 Ω
    P13-5 or P10-1 - Body ground
    		10 kΩ or higher
    P13-2 or P10-2 - Body ground
    		10 kΩ or higher


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY
Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Windshield Windowglass.Power Window Control System (For Rhd).Power Window Control System (For Rhd) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Remove the motor (Toyota Fortuner RM00000138Z003X.html).

  1. Apply battery voltage to connector terminals 1 and 2.

  1. Check that the motor gear rotates smoothly as follows.

    OK:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    		Motor gear rotates counterclockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    		Motor gear rotates clockwise


NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY
OK


5.CHECK WIRE HARNESS (MASTER SWITCH - REGULATOR SWITCH)

Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Windshield Windowglass.Power Window Control System (For Rhd).Power Window Control System (For Rhd) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Disconnect the P6 master switch connector.

  1. Disconnect the P13 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    		Specified Condition
    P6-16 (RRU) - P13-1
    		Below 1 Ω
    P6-15 (RRD) - P13-4
    		Below 1 Ω
    P6-16 (RRU) or P13-1 - Body ground
    		10 kΩ or higher
    P6-15 (RRD) or P13-4 - Body ground
    		10 kΩ or higher


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (for Rear RH Switch)
Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Windshield Windowglass.Power Window Control System (For Rhd).Power Window Control System (For Rhd) Rear Power Window Rh Does Not Operate With Rear Power Window Switch Rh

  1. Remove the master switch (Toyota Fortuner RM00000138V003X.html).

  1. Measure the resistance of the switch when the switch is operated.

    Standard resistance:

    Tester Connection
    		Window Lock Switch Condition
    		Rear RH Switch Condition
    		Specified Condition
    3 (E) - 15 (RRD), 6 (B) - 16 (RRU)
    		OFF
    		UP
    		Below 1 Ω
    3 (E) - 16 (RRU), 3 (E) - 15 (RRD)
    		OFF
    		OFF
    		Below 1 Ω
    3 (E) - 16 (RRU), 6 (B) - 15 (RRD)
    		OFF
    		DOWN
    		Below 1 Ω
    3 (E) - 15 (RRD)
    		ON
    		UP
    		10 kΩ or higher
    6 (B) - 16 (RRU)
    		Below 1 Ω
    16 (RRU) - 15 (RRD)
    		ON
    		OFF
    		Below 1 Ω
    3 (E) - 16 (RRU)
    		ON
    		DOWN
    		10 kΩ or higher
    6 (B) - 15 (RRD)
    		Below 1 Ω


NG
REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
OK

GO TO POWER WINDOWS DO NOT OPERATE AT ALL