Power Point Socket -- Installation |
| 1. INSTALL REAR POWER POINT SOCKET ASSEMBLY |
 |
Attach the 2 claw fittings to install the socket.
| 2. INSTALL QUARTER INSIDE TRIM BOARD LH |
Connect the power point socket connector.
Detach the 7 claws and 10 clips to install the quarter inside trim board.
Install the clip.
Connect the rear No. 2 seat outer belt floor anchor with the bolt.
- Torque:
- 42 N*m{428 kgf*cm, 31 ft.*lbf}
Connect the rear No. 1 seat outer belt floor anchor with the bolt.
- Torque:
- 42 N*m{428 kgf*cm, 31 ft.*lbf}
Attach the 2 claws to install the outer lap belt anchor cover.
- HINT:
- Use the same procedure for both outer lap belt anchor covers.
| 3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH |
 |
Align the paint mark on the rear door opening trim weatherstrip with the mark position on the vehicle and install the rear door opening trim weatherstrip as shown in the illustration.
Text in Illustration *1 Paint Mark *2 Mark Position
| 4. INSTALL REAR DOOR SCUFF PLATE LH |
Attach the 2 clips and 7 claws to install the rear door scuff plate.
| 5. INSTALL BACK DOOR SCUFF PLATE |
Attach the 4 claws, 2 guides and 6 clips to install the back door scuff plate.
| 6. INSTALL POWER POINT SOCKET ASSEMBLY |
 |
Align the protrusion on the backside of the socket with the groove of the cover. Then push the socket into the cover.
| 7. INSTALL SWITCH BASE |
Connect the connectors.
Attach the 9 claws and guide to install the switch base.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Toyota Fortuner RM000004W63000X.html).