Meter / Gauge System Driver Side Seat Belt Warning Light Does Not Operate
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT FRONT SEAT INNER BELT ASSEMBLY (BUCKLE SWITCH)
CHECK WIRE HARNESS (INNER BELT - METER AND BODY GROUND)
METER / GAUGE SYSTEM - Driver Side Seat Belt Warning Light does not Operate |
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (BUCKLE SWITCH) |
Disconnect the F11 belt connector.
Measure the resistance of the buckle switch.
- Standard resistance:
Tester Connection
| Condition
| Specified Condition
|
1 - 2
| Seat belt is unfastened (ON)
| Below 1 Ω
|
1 - 2
| Seat belt is fastened (OFF)
| 10 kΩ or higher
|
| | REPLACE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) |
|
|
| 2.CHECK WIRE HARNESS (INNER BELT - METER AND BODY GROUND) |
Disconnect the F11 belt connector.
Disconnect the C10 meter connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
| Specified Condition
|
F11-1 - C10-11
| Below 1 Ω
|
F11-2 - Body ground
| Below 1 Ω
|
F11-1 - Body ground
| 10 kΩ or higher
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
|
|
| REPLACE COMBINATION METER ASSEMBLY |
|
