Side Turn Signal Light Assembly Installation

Connect the connector.

Install the side turn signal light assembly LH with the 2 screws.

Attach the 2 claws as shown in the illustration.

Attach the 6 claws to install the outer mirror cover LH.

After installing the outer mirror cover, check that there is no gap between the cover and mirror body.
If there is a gap between the cover and body, noise will occur during driving.

Using a T25 "TORX" socket wrench, install the screw.

HINT:

1. Clean the threads of the screw with non-residue solvent.
   
2. Apply adhesive to the threads of the screw.
   

   Adhesive:

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
   

Using a T25 "TORX" socket wrench, install the screws.

HINT:

1. Clean the threads of the screws with non-residue solvent.
   
2. Apply adhesive to the threads of the screws.
   

   Adhesive:

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
   

Attach the 5 claws.

Install the rubber base with the screw.

Apply new tape as shown in the illustration.

Attach the 2 claws as shown in the illustration.

Attach the 2 clips to install the outer mirror LH.

NOTICE:

Do not push in the glass with excessive force. Doing so may break the mirror surface.