Engine Immobiliser System Dtc Check / Clear

  1. CHECK DTC (USING INTELLIGENT TESTER)

  1. CHECK DTC (NOT USING INTELLIGENT TESTER)

  1. CLEAR DTC (USING INTELLIGENT TESTER)

  1. CLEAR DTC (NOT USING INTELLIGENT TESTER)

Engine Immobiliser System -- Dtc Check / Clear



CHECK DTC (USING INTELLIGENT TESTER)


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Engine Immobiliser.Engine Immobiliser System.Engine Immobiliser System Dtc Check / Clear

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Read the DTCs by following the directions on the tester's screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

CHECK DTC (NOT USING INTELLIGENT TESTER)


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Engine Immobiliser.Engine Immobiliser System.Engine Immobiliser System Dtc Check / Clear

  1. Turn the ignition switch ON.

  2. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

    SST
    09843-18040


    3. Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Engine Immobiliser.Engine Immobiliser System.Engine Immobiliser System Dtc Check / Clear

  3. Read DTCs by observing the MIL. If no DTCs are detected, the MIL blinks as shown in the illustration.



  4. If DTCs 12 and 99 are detected, the MIL flashes as shown in the illustration (malfunction code). If the interval between the previous DTC and the next DTC is 4.5 seconds, it means the previous DTC is the last one of the detected DTCs. Then the MIL repeats the indication of the DTCs (refer to the illustration (malfunction code)).


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Engine Immobiliser.Engine Immobiliser System.Engine Immobiliser System Dtc Check / Clear

  5. Check the details of the malfunction using the DTC chart (Toyota Fortuner RM000000Z33004X.html).

  6. After completing the check, disconnect terminals 13 (TC) and 4 (CG) and turn off the display.


CLEAR DTC (USING INTELLIGENT TESTER)


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Engine Immobiliser.Engine Immobiliser System.Engine Immobiliser System Dtc Check / Clear

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Erase the DTCs by following the directions on the tester's screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

CLEAR DTC (NOT USING INTELLIGENT TESTER)


  1. Perform either of the following operations.

    1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.



      2. Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Engine Immobiliser.Engine Immobiliser System.Engine Immobiliser System Dtc Check / Clear

    2. Remove the EFI and ETCS fuses from the engine room relay block and junction block for more than 60 seconds, or disconnect the battery cable for more than 60 seconds.