Compressor And Magnetic Clutch (For 1Gr-Fe) -- Removal |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Turn the A/C switch ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, discharge the refrigerant gas.
- SST
- 09985-20010(09985-02130,09985-02150,09985-02090,09985-02110,09985-02010,09985-02050,09985-02060,09985-02070)
| 2. REMOVE DRIVE BELT |
While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner.
 |
| 3. DISCONNECT SUCTION HOSE SUB-ASSEMBLY |
Remove the bolt and disconnect the suction hose sub-assembly from the compressor.
 |
Remove the O-ring from the suction hose sub-assembly.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
| 4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor.
 |
Remove the O-ring from the No. 1 cooler refrigerant discharge hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
| 5. REMOVE COOLER COMPRESSOR ASSEMBLY |
 |
Disconnect the connector.
Remove the 4 bolts and cooler compressor assembly.
 |