Rear Propeller Shaft Assembly -- Removal |
| 1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for Pre-Runner) |
 |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.
Remove the center support bearing's 2 set bolts and 2 plates from the frame crossmember.
 |
Pull out the propeller shaft.
 |
Install SST in the transmission to prevent oil leakage.
- SST
- 09325-40010
| 2. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 4WD) |
 |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts and 4 washers, and disconnect the propeller shaft.
Place matchmarks on the propeller shaft flange and differential flange.
 |
Remove the 4 nuts, 4 bolts and 4 washers.
Remove the propeller shaft.
| 3. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY |
Check the spider bearings for wear or damage.
Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.
- Maximum bearing axial play:
- 0 to 0.05 mm (0 to 0.002 in.)