Rear Planetary Gear Reassembly

Install the ring gear flange.

Using a screwdriver, install the snap ring.

Coat the races and the bearing with petroleum jelly, and install them onto the planetary ring gear.

Races and Bearing Diameter:

Item	Inside	Outside
Race (A)	28.5 mm (1.12 in.)	44.2 mm (1.70 in.)
Assembled bearing and race (B)	27.7 mm (1.09 in.)	44.2 mm (1.70 in.)

Coat the thrust washer with petroleum jelly.

Install the thrust washer onto both sides of the planetary gear.

HINT:

Make sure that the tabs of the washer fit into the cutout portions of the planetary gear.

Coat the thrust washer with petroleum jelly.

Install the thrust washer onto both sides of the planetary gear.

HINT:

Make sure that the tabs of the washer fit into the cutout portions of the planetary gear.

Install the one-way clutch and 2 retainers into the planetary gear.

HINT:

Make sure that the open ends of the guides on the one-way clutch are facing upward.

Using a screwdriver, install the snap ring.

While turning the one-way clutch inner race counterclockwise, install the one-way clutch inner race to the planetary gear.

Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locks when turned clockwise.

Coat the oil seal ring with ATF, and install it to the output shaft.

HINT:

After installing the oil seal ring, check that it rotates smoothly.

NOTICE:

Do not expand the ring excessively.