Glow Relay On-Vehicle Inspection


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE GLOW RELAY

  3. INSPECT GLOW RELAY

  4. INSTALL GLOW RELAY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Glow Relay -- On-Vehicle Inspection



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.


2. REMOVE GLOW RELAY

  1. Remove the engine room relay block cover.

  1. Remove the glow relay from the engine room relay block.



3. INSPECT GLOW RELAY


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.5L-E Starting.Glow Relay.Glow Relay On-Vehicle Inspection

  1. Measure the resistance of the glow relay.

    Standard resistance:
    Tester Connection
    		Specified Condition
    3 - 5
    		10 kΩ or higher
    3 - 5
    		Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)
    If the result is not as specified, replace the relay.


4. INSTALL GLOW RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL