Remove no. 1 brake actuator bracket. Remove brake master cylinder reservoir sub-assembly. Remove master cylinder reservoir grommet. Remove no. 1 brake actuator hose. Remove no. 1 brake actuator tube.

Remove no. 1 brake actuator bracket. Remove brake master cylinder reservoir sub-assembly. Remove master cylinder reservoir grommet. Remove no. 1 brake actuator hose. Remove no. 1 brake actuator tube.

Inspect brake master cylinder fluid pressure change Inspect brake master cylinder operation Check fluid level in reservoir

Inspect brake master cylinder fluid pressure change Inspect brake master cylinder operation Check fluid level in reservoir

DTC check Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3. SST 09843-18040 Turn the ignition switch to ON. Read the DTCs from the ABS warning light on the combination meter.

HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary. Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Description The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check. Connecting terminals TS and CG of the DLC3 starts the check. Wiring diagram

Descripcion El modo de salida de DTC se establece conectando los terminales TC y CG del DLC3.Los DTC se emiten mediante el parpadeo de la luz de advertencia del ABS. Diagrama de cableado

Description The skid control buzzer sounds while the accumulator pressure is abnormally low or an abnormality causing low fluid pressure occurs. Wiring diagram

Description The BRAKE warning light comes on when brake fluid is insufficient, the parking brake is applied or the EBD is defective.