Rear Airbag Sensor Installation

Check that the ignition switch is off.

Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Install the rear airbag sensor with the bolt.

Torque:

9.0 N*m{92 kgf*cm, 80 in.*lbf}

NOTICE:

1. If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
   
2. When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
   

Check that there is no looseness in the installation parts of the rear airbag sensor.

Connect the connector.

Install the 2 belt hangers to the trim board.

Connect the power point socket connector.

Attach the 10 clips and 6 claws to install the quarter inside trim board.

Install the clip labeled A.

Install the quarter trim hook with the screw.

Connect the rear outer No. 1 seat belt anchor.

1. Connect the anchor with the bolt.
   

   Torque:

   42 N*m{428 kgf*cm, 31 ft.*lbf}

2. Attach the 2 claws to install the outer lap belt anchor cover.
   

Connect the rear outer No. 2 seat belt anchor.

1. Connect the anchor with the bolt.
   

   Torque:

   42 N*m{428 kgf*cm, 31 ft.*lbf}

2. Attach the 2 claws to install the outer lap belt anchor cover.
   

Install the quarter trim jack cover.

Attach the 6 clips and 4 claws to install the back door scuff plate.

Install the rear door opening trim weatherstrip.

Attach the 2 clips and 7 claws to install the rear door scuff plate.

Install the rear seat assembly (Toyota Fortuner RM000001DOI002X.html).

Check the SRS warning light (Toyota Fortuner RM000000XFD06DX.html).