Front Power Seat Motor Assembly (For Rear Lifter) Installation

Using a 4 mm socket hexagon wrench, install the motor with the 2 bolts.

Torque:

2.5 N*m{25 kgf*cm, 22 in.*lbf}

Clean the threads of the "TORX" bolt for the adjust screw with non-residue solvent (when reusing the "TORX" bolt).

Apply adhesive to the threads of the "TORX" bolt for the adjust screw (when reusing the "TORX" bolt).

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

Using a T40 "TORX" socket wrench, install the "TORX" bolt.

Torque:

25 N*m{255 kgf*cm, 18 ft.*lbf}

Connect the connector.

Using a T40 "TORX" socket wrench, install the tilt rod with the 2 "TORX" bolts for the tilt rod.

Torque:

25 N*m{255 kgf*cm, 18 ft.*lbf}

Install the nut.

Install the seat cushion frame with the 4 bolts.

Torque:

19 N*m{194 kgf*cm, 14 ft.*lbf}

Attach the 4 clamps indicated by the arrows in the illustration to install the seat cushion spring.

w/o Front Seat Side Airbag:
Attach the 2 wire harness clamps.

w/ Front Seat Side Airbag:
Attach the 3 wire harness clamps.

NOTICE:

Be careful not to damage the airbag wire harness or connector.

Attach the hooks to install the seat cushion cover with pad.

Using hog ring pliers, attach the rubber bands of the seatback cover to the seat frame with new hog rings.

NOTICE:

1. Be careful not to damage the cover.
   
2. When installing the hog rings, avoid wrinkling the cover.
   

Install the buckle cover.

Install the front seat inner belt assembly with the nut.

Torque:

42 N*m{428 kgf*cm, 31 ft.*lbf}

NOTICE:

Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.

Connect the connector and attach the 3 clamps.

Pass the wire harness of the front seat inner belt assembly below the claw and into the front seat cushion inner shield.

Attach the claw to temporarily install the cushion inner shield.

NOTICE:

Make sure that the wire harness of the front seat inner belt assembly is not being pinched inside the front seat cushion inner shield.

Attach the guide and claw.

NOTICE:

Make sure that the wire harness of the front seat inner belt assembly is not being pinched inside the front seat cushion inner shield.

Install the screw to the cushion inner shield.

Connect the connector.

Install the switch with the 3 screws.

Attach the claw and guide to install the cushion shield.

Install the 3 screws.

Install the 2 screws.

Attach the 4 claws to install the knob.

Attach the 2 claws to install the knob.

Install the front seat assembly (Toyota Fortuner RM000003NZV00FX.html).

Check the SRS warning light (Toyota Fortuner RM000000XFD06DX.html).

Check the power seat operation (Toyota Fortuner RM000003REB000X.html).