Can Communication System (W/ Vsc) System Description

  1. BRIEF DESCRIPTION

  1. DEFINITION OF TERMS

  1. ECUS OR SENSORS WHICH COMMUNICATE VIA CAN COMMUNICATION SYSTEM

  1. DIAGNOSTIC CODES FOR CAN COMMUNICATION SYSTEM

  1. NOTES REGARDING TROUBLESHOOTING

  1. HOW TO DISTINGUISH CAN JUNCTION CONNECTOR CONNECTORS

Can Communication System (W/ Vsc) -- System Description



BRIEF DESCRIPTION

  1. The CAN (Controller Area Network) is a serial data communication system for real-time application. It is a vehicle multiplex communication system which has a high communication speed (500 kbps) and the ability to detect malfunctions.

  2. By pairing the CANH and CANL bus lines, the CAN performs communication based on differential voltages.

  3. Many ECUs (sensors) installed on the vehicle operate by sharing information and communicating with each other.

  4. The CAN has 2 resistors of 120 Ω which are necessary to communicate using the main wire.


DEFINITION OF TERMS

  1. Main wire

    1. The main wire is a wire harness between the 2 termination circuits on the bus (communication line). This is the main bus in the CAN communication system.

  2. Branch wire

    1. The branch wire is a wire harness which diverges from the main wire to an ECU or sensor.

  3. Termination circuits

    1. The termination circuit is a circuit which converts the communication current of the CAN communication into the bus voltage. It consists of a resistor and capacitor. 2 termination circuits are necessary on a bus.

  4. CAN junction connector

    1. The CAN junction connector is designed so that it can be used with CAN communication which has a termination circuit and CAN communication which does not have a termination circuit.


ECUS OR SENSORS WHICH COMMUNICATE VIA CAN COMMUNICATION SYSTEM

  1. ECM

  2. Skid control ECU

  3. Steering angle sensor

  4. Yaw rate sensor


DIAGNOSTIC CODES FOR CAN COMMUNICATION SYSTEM

  1. DTCs for the CAN communication system are as follows: U0073, U0100, U0123, U0124 and U0126.


NOTES REGARDING TROUBLESHOOTING

  1. Trouble in the CAN bus (communication line) can be checked through the DLC3 (except when there is a wire break in the branch wire of the DLC3).

    NOTICE:
    Do not connect the tester directly to the DLC3. Be sure to use a service wire.

  2. DTCs regarding the CAN communication system can be checked using the intelligent tester.

  3. The CAN communication system cannot detect trouble in the branch line of the DLC3 even though the DLC3 is also connected to the CAN communication system.


HOW TO DISTINGUISH CAN JUNCTION CONNECTOR CONNECTORS

  1. In the CAN communication system, the shape of all connectors connected to the CAN junction connector is the same. The connectors connected to the CAN junction connector can be distinguished by the colors of the bus line and the connecting side of the connector.

    HINT:
    See "Terminals of ECU" (Toyota Fortuner RM000002VT3008X.html) for bus line color or the type of connecting surface.