Theft Deterrent System Ignition Switch Circuit

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

INSPECT IGNITION SWITCH ASSEMBLY

CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - BATTERY AND BODY GROUND)

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:

1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
   
2. When replacing the theft warning ECU assembly, refer to the registration procedures (Toyota Fortuner RM000000Z4Z008X.html).
   

1. Remove the ignition switch assembly.
   

   1. for 1GR-FE: Toyota Fortuner RM0000013XF00AX.html
      
   2. for 2TR-FE: Toyota Fortuner RM00000135Z00DX.html
      
   3. for 1KD-FTV: Toyota Fortuner RM0000013XF009X.html
      
   4. for 2KD-FTV: Toyota Fortuner RM0000013XF01EX.html
      

2. Measure the resistance according to the value(s) in the table below.
   

   Standard Resistance:

   Tester Connection	Switch Condition	Specified Condition
   1 (IG1) - 4 (AM1)	Off, ACC	10 kΩ or higher
   1 (IG1) - 4 (AM1)	ON, START	Below 1 Ω

   Result

   Result	Proceed to
   OK	A
   NG (for 1GR-FE)	B
   NG (for 2TR-FE)	C
   NG (for 1KD-FTV)	D
   NG (for 2KD-FTV)	E

1. Disconnect the T36 theft warning ECU assembly connector.
   

2. Measure the resistance according to the value(s) in the table below.
   

   Standard Resistance:

   Tester Connection	Condition	Specified Condition
   T36-1 (E) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.
   

   Standard Voltage:

   Tester Connection	Switch Condition	Specified Condition
   T36-4 (IG) - Body ground	Ignition switch OFF	Below 1 V
   T36-4 (IG) - Body ground	Ignition switch ON	11 to 14 V