Rear Wiper Motor Installation

Install the wiper motor with the 3 bolts.

Torque:

8.3 N*m{85 kgf*cm, 73 in.*lbf}

Connect the connector.

Stop the wiper motor at the automatic stop position.

Clean the wiper arm serration with a round file or equivalent.

Clean the wiper pivot serration with a wire brush.

Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

Torque:

8.4 N*m{86 kgf*cm, 74 in.*lbf}

HINT:

1. Hold down the arm hinge by hand while tightening the nut.
   
2. Install the arm and blade so that the rear wiper blade is aligned with the ceramic line.
   

Operate the rear wiper while spraying water or washer fluid on the glass. Ensure that there is no interference between the blade and pillar.

Install the trim board and attach the 16 clips.