Rear Seat Outer Belt Assembly -- Removal |
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the RH side.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH |
 |
Remove the 2 bolts.
Unlock the seat legs by horizontally pulling the release band. Then remove the seat.
- NOTICE:
- Be careful not to damage the vehicle body,
| 3. REMOVE BACK DOOR SCUFF PLATE |
Using a screwdriver, detach the 4 claws.
- HINT:
- Tape the screwdriver tip before use.
 |
Using a clip remover, detach the 6 clips and remove the scuff plate.
| 4. REMOVE REAR DOOR SCUFF PLATE RH |
- HINT:
- Use the same procedures described for the LH side.
| 5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
| 6. REMOVE QUARTER TRIM HOOK |
| 7. DISCONNECT REAR NO. 1 SEAT BELT ASSEMBLY OUTER RH |
 |
Detach the 2 claws and remove the lap belt outer anchor cover.
Remove the bolt and disconnect the seat belt.
| 8. DISCONNECT REAR NO. 2 SEAT BELT ASSEMBLY OUTER RH |
 |
Disconnect the rear No. 2 seat belt outer anchor.
Detach the 2 claws and remove the lap belt outer anchor cover.
Remove the bolt and disconnect the seat belt.
| 9. REMOVE QUARTER INSIDE TRIM BOARD RH |
Disconnect the rear No. 1 seat belt outer anchor.
Detach the 2 claws and remove the lap belt outer anchor cover.
Remove the bolt and disconnect the anchor.
|
Disconnect the rear No. 2 seat belt outer anchor.
Detach the 2 claws and remove the lap belt outer anchor cover.
Remove the bolt and disconnect the anchor.
Remove the screw and quarter trim hook.
Using a clip remover, remove the clip labeled A.
 |
Using a screwdriver, detach the 6 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 10 clips and remove the trim board.
Disconnect the cooler control switch connector.
Remove the 2 belt hangers.
| 10. REMOVE REAR NO. 1 SEAT BELT ASSEMBLY OUTER RH |
 |
Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
Remove the bolt and disconnect the seat belt's shoulder anchor.
Remove the bolt and seat belt.
 |
| 11. REMOVE REAR NO. 2 SEAT BELT ASSEMBLY OUTER LH |
|
Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
Remove the bolt and disconnect the seat belt's shoulder anchor.
Remove the bolt and seat belt.
 |