Outer Rear View Mirror -- Installation |
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Toyota Fortuner RM00000118W017X.html).
| 1. INSTALL OUTER MIRROR COVER LH |
Attach the 2 claws as shown in the illustration.
Attach the 6 claws to install the outer mirror cover LH.
After installing the outer mirror cover, check that there is no gap between the cover and mirror body.
If there is a gap between the cover and body, noise will occur during driving.
 |
Using a T25 "TORX" socket wrench, install the screw.
- HINT:
- Clean the threads of the screw with non-residue solvent.
- Apply adhesive to the threads of the screw.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Text in Illustration *1 Adhesive
 |
Using a T25 "TORX" socket wrench, install the screws.
- HINT:
- Clean the threads of the screws with non-residue solvent.
- Apply adhesive to the threads of the screws.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Text in Illustration *1 Adhesive
 |
Attach the 5 claws.
Install the rubber base with the screw.
Apply new tape as shown in the illustration.
Text in Illustration *1 Tape *a 40 mm (1.58 in.)
 |
| 2. INSTALL OUTER MIRROR LH |
Attach the 2 claws as shown in the illustration.
 |
Attach the 2 clips to install the outer mirror LH.
- NOTICE:
- Do not push in the glass with excessive force. Doing so may break the mirror surface.
 |
| 3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH |
 |
Install the outer rear view mirror assembly LH with the 3 nuts.
- Torque:
- 8.0 N*m{82 kgf*cm, 71 ft.*lbf}
Connect the connector.
| 4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
Attach the 8 clips to install the front door trim board.
Install the screw and clip.
| 5. INSTALL DOOR PULL HANDLE |
Install the door pull handle with the screw.
| 6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
Attach the 2 clips to install the front door lower frame bracket garnish.
| 7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL LH (for Driver Side) |
Connect the connector.
Attach the 4 claws and 2 clips to install the power window regulator switch assembly with front door armrest base panel.
| 8. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL RH (for Front Passenger Side) |
Connect the connector.
Attach the 4 claws and 2 clips to install the power window regulator master switch assembly with front door armrest base panel.