Generator Installation

Install the generator and adjusting bar with the 2 bolts.

Torque:

43 N*m{438 kgf*cm, 32 ft.*lbf}

Install the generator wire with the nut.

Torque:

9.8 N*m{100 kgf*cm, 87 in.*lbf}

Install the terminal cap.

Connect the generator connector.

While turning the belt tensioner counterclockwise, align its holes, and then insert a pin of φ6 mm (0.24 in.) into the holes to fix the belt tensioner.

Install the V-ribbed belt.

HINT:

If it is hard to install the V-ribbed belt, perform the following procedure.

1. Put the V-ribbed belt on everything except the PS pump as shown in the illustration.
   

2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the PS pump.
   

While turning the belt tensioner counterclockwise, remove the pin.