Hazard Warning Switch Removal


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER

  3. REMOVE HEATER CONTROL KNOB

  4. REMOVE FRE/REC CONTROL KNOB

  5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

Hazard Warning Switch -- Removal


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Lighting.Hazard Warning Switch.Hazard Warning Switch Removal
HINT:
To prevent the clips from falling, horizontally pull out the panel. Hold both sides of the panel in the locations indicated by the arrows in the illustration.

  1. Remove the screw <C>.

  1. Detach the 6 claws and 4 clips.

    NOTICE:
    Make sure the center registers are not removed.

  1. Disconnect all connectors and remove the panel.



3. REMOVE HEATER CONTROL KNOB


Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Lighting.Hazard Warning Switch.Hazard Warning Switch Removal

  1. Remove the 3 control knobs.



4. REMOVE FRE/REC CONTROL KNOB


Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Lighting.Hazard Warning Switch.Hazard Warning Switch Removal

  1. Remove the control knob.



5. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.Lighting.Hazard Warning Switch.Hazard Warning Switch Removal

  1. Detach the 2 claws and remove the switch.