Headlight Assembly (For Halogen Headlight) -- Removal |
- HINT:
- Use the same procedures for the RH and LH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Toyota Fortuner RM00000118W017X.html).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE RADIATOR GRILLE |
Remove the 2 screws.
 |
Using a clip remover, remove the 2 clips.
Pull the radiator grille in the direction indicated by the arrow in the illustration to detach the 6 claws and remove the radiator grille.
| 3. REMOVE FRONT FENDER LINER LH |
Remove the screw.
 |
Using a clip remover, remove the 3 clips.
Partially remove the fender liner.
- HINT:
- It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in the next step.
| 4. REMOVE FRONT BUMPER COVER |
 |
Using a clip remover, remove the 11 clips.
Put protective tape under the front fender.
 |
Detach the 8 claws and remove the cover.
Disconnect the 2 fog light connectors.
| 5. REMOVE HEADLIGHT ASSEMBLY |
 |
Remove the 3 screws and bolt.
Disconnect the connectors and remove the headlight.