Ignition Key Cylinder Light -- Installation |
| 1. INSTALL KEY CYLINDER LIGHT ASSEMBLY |
Connect the connector.
 |
Push in the key cylinder light assembly in the direction indicated by the arrow in the illustration to install it.
| 2. INSTALL STEERING COLUMN COVER UPPER |
 |
Install the lower cover with the 3 screws.
- Torque:
- 2.0 N*m{20 kgf*cm, 18 in.*lbf}
| 3. INSTALL STEERING COLUMN COVER LOWER |
|
Install the lower cover with the 3 screws.
- Torque:
- 2.0 N*m{20 kgf*cm, 18 in.*lbf}
| 4. INSTALL STEERING WHEEL ASSEMBLY |
 |
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
- Torque:
- 50 N*m{510 kgf*cm, 37 ft.*lbf}
| 5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD |
| 6. INSPECT STEERING WHEEL CENTER POINT |
| 7. INSTALL STEERING PAD ASSEMBLY |
 |
Support the steering pad with one hand as shown in the illustration.
Connect the airbag connector.
- NOTICE:
- When handling the airbag connector, do not damage the airbag wire harness.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Using a T30 "torx" socket, install the 2 screws.
- Torque:
- 8.8 N*m{90 kgf*cm, 78 in.*lbf}
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 9. INSPECT STEERING PAD ASSEMBLY |
Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
Check that the horn sounds.
| 10. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Toyota Fortuner RM0000010AQ003X_02_0005.html).