Starter Relay On-Vehicle Inspection


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE STARTER RELAY (Marking: ST)

  3. INSPECT STARTER RELAY

  4. INSTALL STARTER RELAY

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Starter Relay -- On-Vehicle Inspection



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.


2. REMOVE STARTER RELAY (Marking: ST)

  1. Remove the engine room relay block cover.

  1. Remove the starter relay from the engine room relay block.



3. INSPECT STARTER RELAY


    Toyota Fortuner. Ggn50, 60 Kun51, 61 Tgn51 Lan50.5L-E Starting.Starter Relay.Starter Relay On-Vehicle Inspection

  1. Measure the resistance of the starter relay.

    Standard resistance:
    Tester Connection
    		Specified Condition
    3 - 5
    		10 kΩ or higher
    3 - 5
    		Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)
    If the result is not as specified, replace the relay.


4. INSTALL STARTER RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL