Oil Pump Reassembly

Using SST and a hammer, tap in a new oil seal.

SST

09350-30020(09351-32140)

HINT:

The oil seal end should be flush with the outer edge of the pump body.

Coat the lip of the oil seal with MP grease.

Place the oil pump body on the torque converter clutch.

Coat the driven gear with ATF.

Install the driven gear to the oil pump body.

Coat the drive gear with ATF.

Install the drive gear to the oil pump body.

Install a new O-ring to the oil pump body.

Set the stator shaft on the oil pump body while aligning the bolt holes.

Install the 14 bolts.

Torque:

12 N*m{122 kgf*cm, 9 ft.*lbf}

Coat the 3 oil seal rings with ATF.

Squeeze the ends of the 3 oil seal rings together with the overlap distance 8 mm (0.314 in.) or less, and then install them to the stator shaft groove.

NOTICE:

Do not over-spread the ring ends.

HINT:

After installing the oil seal rings, check that they rotate smoothly.

Make sure the drive gear rotates smoothly.

Install a new O-ring to the oil pump.