Generator Installation

Install the generator with the 2 bolts.

Torque:

43 N*m{438 kgf*cm, 32 ft.*lbf}

Install the generator wire with the bolt and nut.

Torque:

9.8 N*m{100 kgf*cm, 87 in.*lbf}

Attach the terminal cap.

Connect the connector.

Install the drive belt to all the pulleys except the drive belt tensioner pulley.

Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

NOTICE:

1. The backside of the drive belt should face the tensioner pulley.
   
2. Check that the drive belt is properly set to each pulley.
   

After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.

Install the air cleaner and intake air connector assembly with the 4 bolts, and tighten the hose clamp.

Torque:

14 N*m{143 kgf*cm, 10 ft.*lbf}for air cleaner

8.0 N*m{82 kgf*cm, 71 in.*lbf}for intake air connector

5.0 N*m{51 kgf*cm, 44 in.*lbf}for hose clamp

Connect the MAF meter connector and harness clamps.

Connect the No. 2 ventilation hose.

Connect the vacuum hose.