Side Turn Signal Light Assembly -- Removal |
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH |
| 2. REMOVE OUTER MIRROR LH |
Using a screwdriver, detach the 2 claws as shown in the illustration.
Text in Illustration *1 Screwdriver *2 Protective Tape - NOTICE:
- Do not pull the outer mirror LH with excessive force. Doing so may cause the actuator to come off or break the mirror surface.
- HINT:
- Apply protective tape to the mirror body and screwdriver tip.
Detach the 2 claws at the upper part of the outer mirror.
 |
Remove the outer mirror LH.
| 3. REMOVE OUTER MIRROR COVER LH |
Remove the tape.
Text in Illustration *1 Tape
 |
Remove the screw, detach the 5 claws and remove the rubber base.
- HINT:
- It is not necessary to completely remove the rubber base. Slightly move the rubber base so that the outer mirror cover LH can be removed in a later step.
 |
Using a T25 "TORX" socket wrench, remove the 3 screws.
 |
Using a T25 "TORX" socket wrench, remove the screw.
 |
Remove the 3 screws.
 |
Detach the 6 claws.
Detach the 2 claws and remove the outer mirror cover LH as shown in the illustration.
| 4. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH |
Remove the 2 screws.
 |
Disconnect the connector and side turn signal light assembly LH.