Park / Neutral Position Switch -- Installation |
| 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
 |
Install the park/neutral position switch to the manual valve shaft.
Temporarily install the bolt.
Install a new lock washer and the nut.
- Torque:
- 7.0 N*m{71 kgf*cm, 62 in.*lbf}
Push the control shaft rearward as much as possible.
 |
Return the control shaft lever 2 notches to the N position.
Align the neutral basic line with the switch groove, and tighten the bolt.
- Torque:
- 13 N*m{133 kgf*cm, 10 ft.*lbf}
 |
Using a screwdriver, bend the tabs of the lock washer.
- HINT:
- Bend at least 2 of the lock washer tabs.
| 2. CONNECT PARK / NEUTRAL POSITION SWITCH CONNECTOR |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSPECT SHIFT LEVER POSITION |
Inspect the shift lever position (Toyota Fortuner RM0000013EW00AX.html).
| 5. ADJUST SHIFT LEVER POSITION |
Adjust the shift lever position (Toyota Fortuner RM0000013EW00AX.html).
| 6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Apply the parking brake and turn the ignition switch ON.
Depress the brake pedal and check that the engine starts when the shift lever is on N or P, but does not start in other positions.
Check that the back-up light illuminates and the reverse warning buzzer sounds when the shift lever is on R, but do not function in other positions.