Fuel Tank Removal

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

Disconnect the fuel pump connector.

Connect the cable to the negative (-) battery terminal.

Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.

HINT:

DTC P0171/25 (system too lean) may be set.

Crank the engine again, and check that the engine does not start.

Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.

Connect the fuel pump connector.

Remove the tube clamp from the fuel tube.

Pinch and pull the main tube connector to disconnect the connector from the pipe. Then pinch and pull the return tube connector to disconnect the connector from the pipe.

NOTICE:

1. Check for foreign matter in the pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the pipe and connector.
   
2. Do not use any tools to separate the pipe and connector.
   
3. Do not forcefully bend or twist the nylon tube.
   
4. Check for foreign matter on the pipe seal surface. Clean if necessary.
   
5. Put the pipe and connector ends in plastic bags to prevent damage and foreign matter contamination.
   
6. If the pipe and connector are stuck together, pinch the connector between your fingers and turn it carefully to disconnect it.
   

Disconnect the filler pipe hose from the fuel tank filler pipe.

Disconnect the breather hose from the fuel tank filler pipe.

Remove the bolt and filler pipe.

Set a mission jack underneath the fuel tank.

Remove the 2 bolts, 2 clips, 2 pins and 2 fuel tank bands.

Slightly lower the mission jack.

NOTICE:

Be careful not to cut the wirings.

Remove the clip. Then fold back approximately half of each cushion rubber so that the wire harness can be removed in the next step.

Disconnect the fuel pump connector and detach the 6 wire harness clips from the fuel tank.

NOTICE:

1. Before this procedure, check the connector for dirt, mud or other contamination.
   
2. Do not use any tools in this procedure.
   

Using needle-nose pliers, remove the 4 clips and nut as shown in the illustration and then remove the heat insulator.

Remove the clip and 2 fuel tank cushions from the fuel tank.

Remove the 2 tube joint clips and pull out the 2 fuel pump tubes.

NOTICE:

1. Before beginning this procedure, check for foreign matter in the fuel suction tube. Clean if necessary.
   
2. Keep the O-ring free from foreign matter, as it becomes contaminated easily.
   
3. Do not use any tools in this procedure.
   
4. Do not forcefully bend or twist the tube.
   
5. Put the tube in a plastic bag to prevent damage and contamination.
   
6. Protect the fuel suction tube's joint with tape or equivalent to prevent contamination from foreign matter.
   
7. If the fuel suction tube and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
   
8. Be careful not to damage any clips. If a clip is damaged, replace it.
   

Using SST, loosen the retainer.

SST

09808-14020(09808-01410,09808-01420,09808-01430)

HINT:

Fit the tips of SST onto the ribs of the retainer.

NOTICE:

1. When the retainer is loosened, be careful as the fuel pump will spring upward from the force of the spring.
   
2. Clean the fuel suction tube before removing it.
   

Remove the retainer.

Remove the fuel gauge tube from the fuel tank.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge.

Remove the gasket from the fuel tank.