Parking Brake Cable -- Removal |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE REAR WHEEL |
| 3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
Release the parking brake lever, and remove the drum.
- HINT:
- If the drum cannot be removed easily, perform the following procedures.
Remove the hole plug (adjust) and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.
 |
Using another screwdriver, compress the shoe adjuster by turning the adjusting wheel.
| 4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
 |
Twist the transmission shift lever knob in the direction indicated by the arrow and remove it.
for 4WD:
Twist the transfer shift lever knob in the direction indicated by the arrow and remove it.
| 5. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY |
 |
Detach the 4 claws and remove the hole cover.
| 6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
 |
- NOTICE:
- Be careful not to damage the instrument panel lower and console box with the claws of the upper console panel.
Detach the 12 claws and remove the console panel.
| 7. REMOVE CONSOLE BOX ASSEMBLY |
 |
Remove the 4 screws <F> and 2 bolts <E>.
Using a clip remover, remove the 2 clips and console box.
| 8. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY |
Disconnect the cable from the parking brake lever (Toyota Fortuner RM000001HKC001X.html).
Remove the 2 bolts and No. 1 heat insulator.
Remove the No. 1 clip and pin.
Disconnect the cable from the No. 3 cable.
Disconnect the cable from the equalizer.
Remove the bolt holding the cable.
Remove the cable from the cable support bracket.
| 9. REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY |
Disconnect the cable from the parking brake shoe lever RH and backing plate RH.
Disconnect the cable from the lever (Toyota Fortuner RM000001HJX005X.html).
Remove the 2 bolts and disconnect the cable from the backing plate.
Remove the 3 bolts and No. 2 heat insulator.
Disconnect the cable from the equalizer as shown in the illustration.
Remove the 4 bolts and cable as shown in the illustration.
| 10. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
Disconnect the cable from the parking brake shoe lever LH and backing plate LH.
Disconnect the cable from the lever (Toyota Fortuner RM000001HJX005X.html).
Remove the 2 bolts and disconnect the cable from the backing plate.
Remove the No. 3 clip as shown in the illustration.
Remove the 4 bolts, nut and cable as shown in the illustration.