Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SUPPLEMENTAL RESTRAINT SYSTEMS
SIDE AIRBAG SENSOR - REMOVAL
- HINT:
Use the same procedures for the RH and LH.
The procedures listed below are the LH side.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
| 2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH |
Detach the clip and claw, and remove the front door lower frame bracket garnish LH.
| 3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH |
Remove the 7 screws and front door inside handle bezel LH.
| 4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY |
Remove the 3 screws and master switch.
| 5. REMOVE ASSIST GRIP COVER LH |
Using a moulding remover, detach the 8 claws and remove the door assist grip cover LH.
| 6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |
Remove the 3 screws.
Remove the 13 clips.
Remove the front inner door glass weatherstrip LH together with the front door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.
- HINT:
- Make sure that the pin labeled A in the illustration is detached from the door panel.
Disconnect the connector.
Disconnect the 2 cables from the front door inside handle sub-assembly LH.
| 7. REMOVE SIDE AIRBAG SENSOR |
Disconnect the connector.
Remove the bolt and side airbag sensor.