METER / GAUGE SYSTEM - Voltage Meter Malfunction

DESCRIPTION

The voltmeter indicates the voltage applied to the IG+ terminal of the combination meter.

Meter / Gauge System - Voltage Meter Malfunction. METER / GAUGE / DISPLAY. Land Cruiser URJ200 URJ202 GRJ200 VDJ200

1.INSPECT FUSE (MET)

Remove the MET fuse from the engine room relay block.

Measure the resistance according to the value(s) in the table below.

REPLACE FUSE

OK

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VOLTMETER)

Operate the intelligent tester according to the display and select Active Test ().

Combination Meter
Tester Display	Test Part	Control Range	Diagnostic Note
Volt meter Operation	Voltmeter	0, 3, 6, 9, 12, 15, or 18	Perform the test with the vehicle stopped and engine idling.

Result
Result	Proceed to
OK	A
NG (w/ Multi-information Display)	B
NG (w/o Multi-information Display)	C

REPLACE COMBINATION METER ASSEMBLY ()

A

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)

Disconnect the E7 meter connector.

Measure the resistance and voltage according to the value(s) in the tables below.

Standard Resistance:
Tester Connection Condition Specified Condition
E7-15 (ET) - Body ground Always Below 1 Ω

Standard Voltage:
Tester Connection Switch Condition Specified Condition
E7-18 (IG+) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V

Result
Result	Proceed to
NG	A
OK (w/ Multi-information Display)	B
OK (w/o Multi-information Display)	C

REPLACE COMBINATION METER ASSEMBLY ()

REPAIR OR REPLACE HARNESS OR CONNECTOR

Tester Connection	Condition	Specified Condition
MET fuse	Always	Below 1 Ω