Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - SEAT BELT

When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.

Align the claws of the vehicle with the seat belt retractor positioning holes.

Install the seat belt with the bolt.

Torque:
8.5 N*m{ 87 kgf*cm, 75 in.*lbf}

Connect the pretensioner connector labeled A as shown in the illustration.

Connect the tension reducer connector labeled B.

w/ Pre-Crash Safety System:

Connect the pre-crash safety connector labeled C.

Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

Torque:
42 N*m{ 428 kgf*cm, 31 ft.*lbf}

3. INSTALL CENTER PILLAR GARNISH LH

Pass the seat belt anchor through the center pillar garnish.

Attach the 2 clips and 2 guides to install the center pillar garnish.

Install the bolt.

4. INSTALL REAR ASSIST GRIP ASSEMBLY

HINT:

Use the same procedure to install the rear assist grip on the other side.

Attach the 2 claws to install the rear assist grip.

Install the 2 bolts.

Attach the 4 claws to install the 2 assist grip plugs.

5. INSTALL CENTER LOWER PILLAR GARNISH

HINT:

for Manual Seat:
When installing the center lower pillar garnish, move the front seat and seatback to the foremost upright position.

for Power Seat:
When installing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.
After moving the front seat, disconnect the cable from the negative (-) battery terminal.

Attach the 2 claws and 7 clips to install the center lower pillar garnish.