Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - THEFT DETERRENT / KEYLESS ENTRY
ENTRY LOCK AND UNLOCK SWITCH (for Front) - INSTALLATION
- HINT:
1. INSTALL FRONT DOOR HANDLE ASSEMBLY OUTSIDE LH |

Install the handle by pushing it in the direction of the arrow in the illustration.

Using a T30 ''TORX'' socket, install the screw.
Connect the connector.
2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH |

Attach the 2 claws to install the front door outside handle cover LH to the front door lock cylinder.
Using a T30 ''TORX'' socket, install the front door outside cover LH (with the door lock cylinder) with the screw.
- Torque:
- 4.0 N*m{ 41 kgf*cm, 35 in.*lbf}
Install the hole plug.
3. INSTALL FRONT DOOR SERVICE HOLE COVER LH |

Apply butyl tape to the door.
Pass the front door lock remote control cable assembly LH and front door inside locking cable assembly LH through a new front door service hole cover LH.
- NOTICE:

Connect the 2 connectors.
Attach the 9 clamps.
Install the bolt as shown in the illustration.
- Torque:
- 8.4 N*m{ 86 kgf*cm, 74 in.*lbf}
4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH |

Connect the connector.
Connect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH to the front door inside handle sub-assembly LH.

Attach the 4 claws and 13 clips to install the front door trim board sub-assembly LH.
Install the 3 screws.
5. INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light) |

Connect the connector.
Attach the claw of the courtesy light to the front door trim.
6. INSTALL DOOR ASSIST GRIP COVER LH |
Attach the 8 claws to install the door assist grip cover LH to the front door trim board sub-assembly LH.
7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH |

Attach the 4 claws to install the front door inside handle bezel LH.
8. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH |
Connect the connector.

Attach the 5 claws to install the armrest base panel.
9. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH |
Attach the clip and claw, and install the front door lower frame bracket garnish LH.
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected ().
11. CHECK SRS WARNING LIGHT |
Check the SRS warning light ().