Land Cruiser URJ200 URJ202 GRJ200 VDJ200 - THEFT DETERRENT / KEYLESS ENTRY
ENTRY AND START SYSTEM (for Entry Function) - CUSTOMIZE PARAMETERS
| CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER |
- HINT:
- The following items can be customized.
- NOTICE:
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Customize Setting.
Select the setting by referring to the table below.
| Display | Default | Contents | Setting |
| Ignition Area (Entry ignition available area) | ALL | Function to choose the available area for the key to start the engine and cancel the steering lock. | FRONT/ALL* |
| Park Wait Time (Waiting time to permit unlocking door after locking) | 2.5s | Function that sets the waiting time to permit unlocking the door after the door is locked with the entry lock function. | 0.5s/1.5s/2.5s/5s |
| Back Door Opening Operation (Back door open mode when vehicle is locked) | LONG | Back door opening the operation. | LONG/TWICE/OFF |
| Display | Default | Contents | Setting |
| Passenger Take Key | ON | Warn a key is taken out by fellow passengers | ON/OFF |
| Key Low Battery Warning (Warn when key battery becomes weak) | ON | Function that warns the driver that the key battery power is low. | ON/OFF |
| Key Out Range Warning | ON | Warn Starting E/G when the key is out of range | ON/OFF |
- HINT:
- *: "FRONT" means front, and "ALL" means front, rear 1 and rear 2.
| Display | Default | Contents | Setting |
| Wireless PBD Operation | 0.8 s (1Motion)* | Function that operates power back door when door control transmitter is pressed in specified way (1-press, 2-presses, 0.8 sec.- press or off). (Function to turn on/off the power back door wireless one motion open operation.)* | 1 Oper or 2 Oper or 0.8 s or OFF (1Motion or 1 Oper or 2 Oper or 0.8 s or OFF)* |
- HINT:
- *: Except Europe
| CUSTOMIZING FUNCTION WITH MULTI-DISPLAY (w/ Multi-display) |
- HINT:
- The following items can be customized.
- NOTICE:
Turn the engine switch on (IG).
Enter the following menus: Setup / Vehicle / Vehicle Settings / Vehicle Customization / Door Lock Settings.
Select the setting by referring to the table below.
| Display | Default | Contents | Setting |
| Select Doors to Unlock | All Doors | Function that sets which doors are unlocked by the entry unlock function. | All Doors or Driver's Door |
| Entry and start system | ON | Function that enables or disables the entry and start system. | On or Off |
| ENTRY UNLOCK MODE SWITCHING FUNCTION |
To use the entry unlock mode switching function, make sure the engine switch is off and simultaneously press and hold the lock switch on the key and another key switch for 5 seconds.
- NOTICE:
- After pressing and holding the switches for 5 seconds, wait 5 seconds before performing the same procedure again.
When a touch sensor is touched, all doors unlock.
When the driver door touch sensor is touched, only the driver door unlocks. When another touch sensor is touched, all doors unlock.
The certification ECU (smart key ECU assembly) receives this signal from the door control receiver and changes the entry and start system to the entry unlock mode.
The certification ECU (smart key ECU assembly) sounds the wireless door lock buzzer and combination meter buzzer to inform the user that the mode has been switched.
- HINT:
- The function only changes the entry unlock mode of the entry and start system. It does not switch the unlocking of the wireless door lock control.
- HINT:
- HINT:
| KEY CANCEL |
The key cancel operation disables the following functions:
The operation procedures are as follows:
Precondition:
Engine switch off, driver side door closed and unlocked.
Unlock the driver side door once with the unlock switch of the key.
Open the driver door within 5 seconds.
Unlock the driver side door twice with the unlock switch of the key within 5 seconds.
Perform close → open twice for the driver door within 30 seconds.
(Driver door: Open condition → Close → Open → Close → Open)
Unlock the driver side door twice with the unlock switch of the key within 5 seconds.
Perform close → open once for the driver door within 30 seconds.
(Driver door: Open condition → Close → Open)
Close the driver door within 5 seconds.
When key cancel is activated, the wireless door lock buzzer sounds twice.
To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.
| WIRELESS BUZZER VOLUME ADJUSTMENT (). |